This AVR programmer is compatible with a popular PonyProg software that shows you a status bar of the programming progress. Like PonyProg it too has a fuses bits setting, however its look and feel is quite different to PonyProg. The socket pcb has been created to fit a 28-DIP AVR ATmega8 microcontroller, but you can build a socket pcb for any other AVR microcontroller out there. If you’re using the AVRISP programming hardware, the programming software is included as part of the AVR Studio program, downloadable from Atmel’s website. You may also use this programmer as a stand alone in-circuit serial programmer that can be used to conveniently program AVR microcontrollers without removing them from the target circuit.Įntire AVR programmer has been build with using common parts and fits in the case of the serial connector. COMPILE PONYPROG ON UBUNTU PonyProg is device programming software for the SI Prog serial interface programmer designed by Claudio Lanconelli. It is more reliable than most other simple AVR programmers available out there and can be built in very short amount of time.ĪVR programmer consists of in-circuit serial programmer (dongle) and small pcb with a DIP socket where you can fit your microcontroller and have it quickly programmed. This simple AVR Programmer will allow you to painlessly transfer hex programs to most ATMEL AVR microcontrollers without sacrificing your budget and time.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |